SH7619_09 Datasheet, PDF (126/860 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7619 Series

Section 6 Interrupt Controller (INTC)
6.3.1 Interrupt Control Register 0 (ICR0)
ICR0 is a 16-bit register that sets the input signal detection mode of the external interrupt input pin
NMI and indicates the input signal level on the NMI pin.
Initial
Bit
Bit Name Value R/W
15
NMIL
1/0
R
14 to 9 
All 0
R
8
NMIE
0
R/W
7 to 0 
All 0
R
Description
NMI Input Level
Indicates the state of the signal input to the NMI pin.
This bit can be read to determine the NMI pin level.
This bit cannot be modified.
0: State of the NMI input is low
1: State of the NMI input is high
Reserved
These bits are always read as 0. The write value
should always be 0.
NMI Edge Select
0: Interrupt request is detected on the falling edge of
the NMI input
1: Interrupt request is detected on the rising edge of
the NMI input
Reserved
These bits are always read as 0. The write value
should always be 0.
Rev. 6.00 Jul. 15, 2009 Page 86 of 816
REJ09B0237-0600