SH7046 Datasheet, PDF (365/611 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7046 Series

Section 12 Serial Communication Interface (SCI)
12.3.5 Serial Mode Register (SMR)
SMR is used to set the SCI’s serial transfer format and select the baud rate generator clock source.
Initial
Bit Bit Name Value R/W
7
C/A
0
R/W
6
CHR
0
R/W
5
PE
0
R/W
4
O/E
0
R/W
3
STOP
0
R/W
2
MP
0
R/W
Description
Communication Mode
0: Asynchronous mode
1: Clocked synchronous mode
Character Length (enabled only in asynchronous mode)
0: Selects 8 bits as the data length.
1: Selects 7 bits as the data length. LSB-first is fixed and
the MSB (bit 7) of TDR is not transmitted in
transmission.
In clocked synchronous mode, a fixed data length of 8 bits
is used.
Parity Enable (enabled only in asynchronous mode)
When this bit is set to 1, the parity bit is added to transmit
data before transmission, and the parity bit is checked in
reception. For a multiprocessor format, parity bit addition
and checking are not performed regardless of the PE bit
setting.
Parity Mode (enabled only when the PE bit is 1 in
asynchronous mode)
0: Selects even parity.
1: Selects odd parity.
Stop Bit Length (enabled only in asynchronous mode)
Selects the stop bit length in transmission.
0: 1 stop bit
1: 2 stop bits
In reception, only the first stop bit is checked. If the
second stop bit is 0, it is treated as the start bit of the next
transmit character.
Multiprocessor Mode (enabled only in asynchronous
mode)
When this bit is set to 1, the multiprocessor
communication function is enabled. The PE bit and O/E bit
settings are invalid in multiprocessor mode.
Rev. 4.00 Dec 05, 2005 page 321 of 564
REJ09B0270-0400