SH7046 Datasheet, PDF (166/611 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7046 Series

Section 8 Data Transfer Controller (DTC)
Chain Transfer: Setting the CHNE bit to 1 enables a number of data transfers to be performed
consecutively in a single activation source. DTSAR, DTDAR, DTMR, DTCRA, and DTCRB can
be set independently.
Figure 8.9 shows the chain transfer.
When activated, the DTC reads the register information start address stored at the vector address,
and then reads the first register information at that start address. After the data transfer, the CHNE
bit will be tested. When it has been set to 1, DTC reads next register information located in a
consecutive area and performs the data transfer. These sequences are repeated until the CHNE bit
is cleared to 0.
In the case of transfer with CHNE set to 1, an interrupt request to the CPU is not generated at the
end of the specified number of transfers or by setting of the DISEL bit to 1, and the interrupt
source flag for the activation source is not affected.
Source
DTC vector
address
Register information
start address
Register information
CHNE = 1
Register information
CHNE = 0
Destination
Source
Figure 8.9 Chain Transfer
Rev. 4.00 Dec 05, 2005 page 122 of 564
REJ09B0270-0400
Destination