SH7046 Datasheet, PDF (171/611 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7046 Series

Section 8 Data Transfer Controller (DTC)
8.5 Cautions on Use
8.5.1 Prohibition against DTC Register Access by DTC
DTC register access by the DTC is prohibited.
8.5.2 Module Standby Mode Setting
DTC operation can be disabled or enabled using the module standby control register. The initial
setting is for DTC operation to be halted. Register access is enabled by clearing module standby
mode.
When the MSTP24 and MSTP25 bits in MSTCR1 are set to 1, the DTC clock is halted and the
DTC enters module standby mode. Do not write 1 on MSTP24 bit or MSTP25 bit during
activation of the DTC.
For details, refer to section 21, Power-Down Modes.
8.5.3 On-Chip RAM
The DTMR, DTSAR, DTDAR, DTCRA,DTCRB and DTIAR registers are all located in on-chip
RAM. When the DTC is used, the RAME bit in SYSCR must not be cleared to 0.
Rev. 4.00 Dec 05, 2005 page 127 of 564
REJ09B0270-0400