SH7046 Datasheet, PDF (355/611 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7046 Series

Section 11 Watchdog Timer
11.4.2 Interval Timer Mode
To use the WDT as an interval timer, clear WT/IT to 0 and set TME to 1 in TCSR. An interval
timer interrupt (ITI) is generated each time the timer counter (TCNT) overflows. This function can
be used to generate interval timer interrupts at regular intervals.
TCNT value
H'FF
Overflow
Overflow
Overflow Overflow
H'00
WT/IT = 0
ITI
ITI
ITI
ITI
TME = 1
ITI: Interval timer interrupt request generation
Figure 11.3 Operation in Interval Timer Mode
Time
11.4.3 Clearing Software Standby Mode
The watchdog timer has a special function to clear software standby mode with an NMI interrupt
or IRQ0 to IRQ3 interrupts. When using software standby mode, set the WDT as described below.
Before Transition to Software Standby Mode: The TME bit in TCSR must be cleared to 0 to
stop the watchdog timer counter before entering software standby mode. The chip cannot enter
software standby mode while the TME bit is set to 1. Set bits CKS2 to CKS0 in TCSR so that the
counter overflow interval is equal to or longer than the oscillation settling time. See section 22.3,
AC Characteristics.
Recovery from Software Standby Mode: When an NMI signal or IRQ0 to IRQ3 signals are
received in software standby mode, the clock oscillator starts running and TCNT starts
incrementing at the rate selected by bits CKS2 to CKS0 before software standby mode was
entered. When TCNT overflows (changes from H'FF to H'00), the clock is presumed to be stable
and usable; clock signals are supplied to the entire chip and software standby mode ends.
For details on software standby mode, see section 21, Power-Down Modes.
Rev. 4.00 Dec 05, 2005 page 311 of 564
REJ09B0270-0400