SH7046 Datasheet, PDF (343/611 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7046 Series

Section 10 Multi-Function Timer Pulse Unit (MTU)
Initial
Bit Bit Name value R/W Description
9
OCE
0
R/W Output Level Compare Enable
This bit enables the start of output level comparisons.
When setting this bit to 1, pay attention to the output pin
combinations shown in table 10.43, Mode Transition
Combinations. When 0 is output, the OSF bit is set to 1
at the same time when this bit is set, and output goes to
high impedance. Accordingly, bits 15 to 11 and bit 9 of
the port E data register (PEDR) are set to 1. For the
MTU output comparison, set the bit to 1 after setting the
MTU's output pins with the PFC. Set this bit only when
using pins as outputs.
When the OCE bit is set to 1, if OIE = 0 a high-
impedance request will not be issued even if OSF is set
to 1. Therefore, in order to have a high-impedance
request issued according to the result of the output level
comparison, the OIE bit must be set to 1. When OCE =
1 and OIE = 1, an interrupt request will be generated at
the same time as the high-impedance request: however,
this interrupt can be masked by means of an interrupt
controller (INTC) setting.
0: Output level compare disabled
1: Output level compare enabled; makes an output high
impedance request when OSF = 1.
8
OIE
0
R/W Output Short Interrupt Enable
This bit makes interrupt requests when the OSF bit of
the OCSR is set.
0: Interrupt requests disabled
1: Interrupt request enabled
7 to 0 
All 0 R
Reserved
These bits are always read as 0. These bits should
always be written with 0.
Note: * The write value should always be 0.
Rev. 4.00 Dec 05, 2005 page 299 of 564
REJ09B0270-0400