MC9S12G Datasheet, PDF (698/1160 Pages) Freescale Semiconductor, Inc – Ignores external trigger. Performs one conversion sequence and stops.

16 KByte Flash Module (S12FTMRG16K1V1)
Table 21-52. Set User Margin Level Command FCCOB Requirements
CCOBIX[2:0]
000
001
0x0D
FCCOB Parameters
Flash block selection code [1:0]. See
Table 21-32
Margin level setting.
Upon clearing CCIF to launch the Set User Margin Level command, the Memory Controller will set the
user margin level for the targeted block and then set the CCIF flag.
NOTE
When the EEPROM block is targeted, the EEPROM user margin levels are
applied only to the EEPROM reads. However, when the P-Flash block is
targeted, the P-Flash user margin levels are applied to both P-Flash and
EEPROM reads. It is not possible to apply user margin levels to the P-Flash
block only.
Valid margin level settings for the Set User Margin Level command are defined in Table 21-53.
Table 21-53. Valid Set User Margin Level Settings
CCOB
(CCOBIX=001)
Level Description
0x0000
Return to Normal Level
0x0001
User Margin-1 Level¹
0x0002
User Margin-0 Level²
1 _{Read margin to the erased state}
2 _{Read margin to the programmed state}
Register
FSTAT
Table 21-54. Set User Margin Level Command Error Handling
Error Bit
ACCERR
FPVIOL
MGSTAT1
MGSTAT0
Error Condition
Set if CCOBIX[2:0] != 001 at command launch
Set if command not available in current mode (see Table 21-25)
Set if an invalid FlashBlockSelectionCode[1:0] is supplied (See Table 21-32 )
Set if an invalid margin level setting is supplied
None
None
None
MC9S12G Family Reference Manual, Rev.1.01
698
Freescale Semiconductor
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.