MC9S12G Datasheet, PDF (45/1160 Pages) Freescale Semiconductor, Inc – Ignores external trigger. Performs one conversion sequence and stops.

Device Overview MC9S12G-Family
1.7.2.13 PP[7:0] / KWP[7:0] — Port P I/O Signals
PP[7:0] are general-purpose input or output signals. The signals can be configured on per signal basis as
interrupt inputs with wakeup capability (KWP[7:0]). They can have a pull-up or pull-down device selected
and enabled on per signal basis. Out of reset the pull devices are disabled .
1.7.2.14 PS[7:0] — Port S I/O Signals
PS[7:0] are general-purpose input or output signals. They can have a pull-up or pull-down device selected
and enabled on per signal basis. Out of reset the pull-up devices are enabled. The signals can be configured
on per pin basis in open-drain mode.
1.7.2.15 PT[7:0] — Port TI/O Signals
PT[7:0] are general-purpose input or output signals. They can have a pull-up or pull-down device selected
and enabled on per signal basis. Out of reset the pull devices are disabled .
1.7.2.16 AN[15:0] — ADC Input Signals
AN[15:0] are the analog inputs of the Analog-to-Digital Converter.
1.7.2.17 ACMP Signals
1.7.2.17.1 ACMPP — Non-Inverting Analog Comparator Input
ACMPP is the non-inverting input of the analog comparator.
1.7.2.17.2 ACMPM — Inverting Analog Comparator Input
ACMPM is the inverting input of the analog comparator.
1.7.2.17.3 ACMPO — Analog Comparator Output
ACMPO is the output of the analog comparator.
1.7.2.18 DAC Signals
1.7.2.18.1 DACU[1:0] Output Pins
These analog pins is used for the unbuffered analog output Voltages from the DAC0 and the DAC1 resistor
network output, when the according mode is selected.
1.7.2.18.2 AMP[1:0] Output Pins
These analog pins are used for the buffered analog outputs Voltage from the operational amplifier outputs,
when the according mode is selected.
MC9S12G Family Reference Manual, Rev.1.01
Freescale Semiconductor
45
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.