MC9S12G Datasheet, PDF (1059/1160 Pages) Freescale Semiconductor, Inc – Ignores external trigger. Performs one conversion sequence and stops.

Register
FSTAT
240 KByte Flash Module (S12FTMRG240K2V1)
Table 28-49. Erase P-Flash Sector Command Error Handling
Error Bit
ACCERR
FPVIOL
MGSTAT1
MGSTAT0
Error Condition
Set if CCOBIX[2:0] != 001 at command launch
Set if command not available in current mode (see Table 28-27)
Set if an invalid global address [17:16] is supplied see Table 28-3)
Set if a misaligned phrase address is supplied (global address [2:0] != 000)
Set if the selected P-Flash sector is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
28.4.6.10 Unsecure Flash Command
The Unsecure Flash command will erase the entire P-Flash and EEPROM memory space and, if the erase
is successful, will release security.
Table 28-50. Unsecure Flash Command FCCOB Requirements
CCOBIX[2:0]
000
FCCOB Parameters
0x0B
Not required
Upon clearing CCIF to launch the Unsecure Flash command, the Memory Controller will erase the entire
P-Flash and EEPROM memory space and verify that it is erased. If the Memory Controller verifies that
the entire Flash memory space was properly erased, security will be released. If the erase verify is not
successful, the Unsecure Flash operation sets MGSTAT1 and terminates without changing the security
state. During the execution of this command (CCIF=0) the user must not write to any Flash module
register. The CCIF flag is set after the Unsecure Flash operation has completed.
Table 28-51. Unsecure Flash Command Error Handling
Register
FSTAT
Error Bit
ACCERR
FPVIOL
MGSTAT1
MGSTAT0
Error Condition
Set if CCOBIX[2:0] != 000 at command launch
Set if command not available in current mode (see Table 28-27)
Set if any area of the P-Flash or EEPROM memory is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
28.4.6.11 Verify Backdoor Access Key Command
The Verify Backdoor Access Key command will only execute if it is enabled by the KEYEN bits in the
FSEC register (see Table 28-10). The Verify Backdoor Access Key command releases security if
user-supplied keys match those stored in the Flash security bytes of the Flash configuration field (see
MC9S12G Family Reference Manual, Rev.1.01
Freescale Semiconductor
1059
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.