MC9S12G Datasheet, PDF (531/1160 Pages) Freescale Semiconductor, Inc – Ignores external trigger. Performs one conversion sequence and stops.

Freescale’s Scalable Controller Area Network (S12MSCANV3)
16.4.5.7 Disabled Mode
The MSCAN is in disabled mode out of reset (CANE=0). All module clocks are stopped for power saving,
however the register map can still be accessed as specified.
16.4.5.8 Programmable Wake-Up Function
The MSCAN can be programmed to wake up from sleep or power down mode as soon as CAN bus activity
is detected (see control bit WUPE in MSCAN Control Register 0 (CANCTL0). The sensitivity to existing
CAN bus action can be modified by applying a low-pass filter function to the RXCAN input line (see
control bit WUPM in Section 16.3.2.2, “MSCAN Control Register 1 (CANCTL1)”).
This feature can be used to protect the MSCAN from wake-up due to short glitches on the CAN bus lines.
Such glitches can result from—for example—electromagnetic interference within noisy environments.
16.4.6 Reset Initialization
The reset state of each individual bit is listed in Section 16.3.2, “Register Descriptions,” which details all
the registers and their bit-fields.
16.4.7 Interrupts
This section describes all interrupts originated by the MSCAN. It documents the enable bits and generated
flags. Each interrupt is listed and described separately.
16.4.7.1 Description of Interrupt Operation
The MSCAN supports four interrupt vectors (see Table 16-39), any of which can be individually masked
(for details see Section 16.3.2.6, “MSCAN Receiver Interrupt Enable Register (CANRIER)” to
Section 16.3.2.8, “MSCAN Transmitter Interrupt Enable Register (CANTIER)”).
Refer to the device overview section to determine the dedicated interrupt vector addresses.
Table 16-39. Interrupt Vectors
Interrupt Source
Wake-Up Interrupt (WUPIF)
Error Interrupts Interrupt (CSCIF, OVRIF)
Receive Interrupt (RXF)
Transmit Interrupts (TXE[2:0])
CCR Mask
Local Enable
I bit
CANRIER (WUPIE)
I bit
CANRIER (CSCIE, OVRIE)
I bit
CANRIER (RXFIE)
I bit
CANTIER (TXEIE[2:0])
16.4.7.2 Transmit Interrupt
At least one of the three transmit buffers is empty (not scheduled) and can be loaded to schedule a message
for transmission. The TXEx flag of the empty message buffer is set.
MC9S12G Family Reference Manual, Rev.1.01
Freescale Semiconductor
531
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.