HD6417705 Datasheet, PDF (729/739 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7700 Series

Category Pin
Reset
Power-on Manual
Reset
Reset
Power-Down States
Bus
Software
Mastership
Standby Sleep
Released I/O
Handling of
Unused Pins
Power
Vcc_USB





supply _{Vss_USB}





voltage
Vcc-RTC





 VccQ
 VssQ
 VccQ
Vss-RTC





 VssQ
AVcc





 VccQ
AVss





 VssQ
VccQ





 VccQ
VssQ





Vcc-PLL1 




Vss-PLL1 




Vcc-PLL2 




Vss-PLL2 




 VssQ

Vcc^*12

Vss^*12

Vcc^*12

Vss^*12
Vcc





 Vcc
Vss





 Vss
Legend:
I
: Input state
i
: Input state (however, input is fixed by the internal logic.)
O
: Output state (high or low, undefined)
L
: Low-level output
H
: High-level output
Z
: High impedance (input/output buffer off)
V
: Input/output buffer off, pull-up on
K
: The high-level output or low-level output/input becomes high impedance.
P
: Input or output depending on the register settings.
Notes:
1. Depends on clock mode.
2. The state is P when the port function is used.
3. The state is K when the port function is used.
4. The state is I when the port function is used.
5. The state is O when the port function is used.
6. The state is Z or H depending on the register settings.
7. The state is Z or L depending on the register settings.
8. The state is Z or O depending on the register settings.
9. The state is i when the USB is not used.
10. The initial value (power-on reset) changes depending on the input level of the
ASEMD0 pin. First, this list shows the value when the ASEMD0 pin is 0, then the
value when the ASEMD0 pin is 1.
Rev. 2.00, 09/03, page 683 of 690