XRT72L50 Datasheet, PDF (376/471 Pages) Exar Corporation – SINGLE CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER

XRT72L50
SINGLE CHANNEL DS3/E3 FRAMER WITH HDLC CONTROLLER
REV. 1.2.1
áç
6.2.2.1 Method 1 - Using the TxOHClk Clock Signal
The Transmit Overhead Data Input Interface consists of the five signals. Of these five (5) signals, the following
four (4) signals are to be used when implementing Method 1.
• TxOH
• TxOHClk
• TxOHFrame
• TxOHIns
Each of these signals are listed and described in Table 69.
TABLE 69: DESCRIPTION OF METHOD 1 TRANSMIT OVERHEAD INPUT INTERFACE SIGNALS
NAME
TYPE
DESCRIPTION
TxOHIns
Input
Transmit Overhead Data Insert Enable input pin.
Asserting this input signal (e.g., setting it "High") enables the Transmit Overhead Data Input Inter-
face to accept overhead data from the Terminal Equipment. In other words, while this input pin is
"High", the Transmit Overhead Data Input Interface will sample the data at the TxOH input pin, on
the falling edge of the TxOHClk output signal.
Conversely, setting this pin "Low" configures the Transmit Overhead Data Input Interface to NOT
sample (e.g., ignore) the data at the TxOH input pin, on the falling edge of the TxOHClk output
signal.
NOTE: If the Terminal Equipment attempts to insert an overhead bit that cannot be accepted by
the Transmit Overhead Data Input Interface (e.g., if the Terminal Equipment asserts the
TxOHIns signal, at a time when one of these non-insertable overhead bits are being
processed), that particular insertion effort will be ignored.
TxOH
Input
Transmit Overhead Data Input pin:
The Transmit Overhead Data Input Interface accepts the overhead data via this input pin, and
inserts into the overhead bit position within the very next Outbound E3 frame. If the TxOHIns pin
is pulled "High", the Transmit Overhead Data Input Interface will sample the data at this input pin
(TxOH), on the falling edge of the TxOHClk output pin. Conversely, if the TxOHIns pin is pulled
"Low", then the Transmit Overhead Data Input Interface will NOT sample the data at this input pin
(TxOH). Consequently, this data will be ignored.
TxOHClk
Output
Transmit Overhead Input Interface Clock Output signal:
This output signal serves two purposes:
1. The Transmit Overhead Data Input Interface will provide a rising clock edge on this signal, one
bit-period prior to the instant that the Transmit Overhead Data Input Interface is processing an
overhead bit.
2. The Transmit Overhead Data Input Interface will sample the data at the TxOH input, on the fall-
ing edge of this clock signal (provided that the TxOHIns input pin is "High").
NOTE: The Transmit Overhead Data Input Interface will supply a clock edge for all overhead bits
within the E3 frame (via the TxOHClk output signal). This includes those overhead bits
that the Transmit Overhead Data Input Interface will not accept from the Terminal
Equipment.
TxOHFrame
Output
Transmit Overhead Input Interface Frame Boundary Indicator Output:
This output signal pulses "High" when the XRT72L50 is processing the last bit within a given E3
frame.
The purpose of this output signal is to alert the Terminal Equipment that the Transmit Overhead
Data Input Interface block is about to begin processing the overhead bits for a new E3 frame.
363