XRT72L50 Datasheet, PDF (299/471 Pages) Exar Corporation – SINGLE CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER

áç
XRT72L50
SINGLE CHANNEL DS3/E3 FRAMER WITH HDLC CONTROLLER
REV. 1.2.1
I/O Control Register (Address = 0x01)
BIT 7
Disable TxLOC
BIT 6
LOC
R/W
RO
1
0
BIT 5
Disable
RxLOC
R/W
1
BIT 4
AMI/ZeroSup*
R/W
0
BIT 3
Unipolar/
Bipolar*
R/W
0
BIT2
BIT 1
TxLine CLK RxLine CLK
Invert
Invert
R/W
R/W
0
0
BIT 0
Reframe
R/W
0
Table 55 relates the contents of this bit field to the clock edge of TxClk that E3 Data is output on the TxPOS
and/or TxNEG output pins.
TABLE 55: THE RELATIONSHIP BETWEEN THE CONTENTS OF BIT 2 (TXLINECLK INV) WITHIN THE I/O CONTROL
REGISTER AND THE TXLINECLK CLOCK EDGE THAT TXPOS AND TXNEG ARE UPDATED ON
BIT 2
0
1
RESULT
Rising Edge:
Outputs on TxPOS and/or TxNEG are updated on the rising edge of TxLineClk.
See Figure 113 for timing relationship between TxLineClk, TxPOS and TxNEG signals, for this selection.
Falling Edge:
Outputs on TxPOS and/or TxNEG are updated on the falling edge of TxLineClk.
See Figure 114 for timing relationship between TxLineClk, TxPOS and TxNEG signals, for this selection.
NOTE: The user will typically make the selection based upon the set-up and hold time requirements of the Transmit LIU IC.
FIGURE 113. WAVEFORM/TIMING RELATIONSHIP BETWEEN TXLINECLK, TXPOS AND TXNEG - TXPOS AND
TXNEG ARE CONFIGURED TO BE UPDATED ON THE RISING EDGE OF TXLINECLK
t₃₂
TxLineClk
t₃₀
t₃₃
TxPOS
TxNEG
286