PIC24FJ64GA705 Datasheet, PDF (321/412 Pages) –

PIC24FJ256GA705 FAMILY
REGISTER 27-1: CTMUCON1L: CTMU CONTROL REGISTER 1 LOW
R/W-0
CTMUEN
bit 15
U-0
R/W-0
R/W-0
—
CTMUSIDL
TGEN
R/W-0
EDGEN
R/W-0
EDGSEQEN
R/W-0
IDISSEN
R/W-0
ITRIM5
bit 7
R/W-0
ITRIM4
R/W-0
ITRIM3
R/W-0
ITRIM2
R/W-0
ITRIM1
R/W-0
ITRIM0
R/W-0
IRNG1
R/W-0
CTTRIG
bit 8
R/W-0
IRNG0
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 15
bit 14
bit 13
bit 12
bit 11
bit 10
bit 9
bit 8
bit 7-2
CTMUEN: CTMU Enable bit
1 = Module is enabled
0 = Module is disabled
Unimplemented: Read as ‘0’
CTMUSIDL: CTMU Stop in Idle Mode bit
1 = Discontinues module operation when device enters Idle mode
0 = Continues module operation in Idle mode
TGEN: Time Generation Enable bit
1 = Enables edge delay generation and routes the current source to the comparator pin
0 = Disables edge delay generation and routes the current source to the selected A/D input pin
EDGEN: Edge Enable bit
1 = Edges are not blocked
0 = Edges are blocked
EDGSEQEN: Edge Sequence Enable bit
1 = Edge 1 event must occur before Edge 2 event can occur
0 = No edge sequence is needed
IDISSEN: Analog Current Source Control bit
1 = Analog current source output is grounded
0 = Analog current source output is not grounded
CTTRIG: CTMU Trigger Control bit
1 = Trigger output is enabled
0 = Trigger output is disabled
ITRIM<5:0>: Current Source Trim bits
011111 = Maximum positive change from nominal current
011110
•
•
•
000001 = Minimum positive change from nominal current
000000 = Nominal current output specified by IRNG<1:0>
111111 = Minimum negative change from nominal current
•
•
•
100010
100001 = Maximum negative change from nominal current
 2016 Microchip Technology Inc.
DS30010118B-page 321