HD64F3437TF16 Datasheet, PDF (95/752 Pages) Hitachi Semiconductor – 12 V must not be applied to the S-mask model (single-power-supply specification), as this may permanently damage the device.

The following sequence is carried out when reset exception handling begins.
1. The internal state of the CPU and the registers of the on-chip supporting modules are
initialized, and the I bit in the condition code register (CCR) is set to 1.
2. The CPU loads the program counter with the first word in the vector table (stored at addresses
H'0000 and H'0001) and starts program execution.
The RES pin should be held low when power is switched off, as well as when power is switched
on.
Figure 4.1 indicates the timing of the reset sequence in modes 2 and 3. Figure 4.2 indicates the
timing in mode 1.
RES/watchdog timer
reset (internal)
ø
Internal address
bus
Internal read
signal
Internal write
signal
Internal data bus
(16 bits)
Vector Internal Instruction
fetch processing prefetch
(1)
(2)
(2)
(3)
(1) Reset vector address (H'0000)
(2) Starting address of program
(3) First instruction of program
Figure 4.1 Reset Sequence (Mode 2 or 3, Program Stored in On-Chip ROM)
66