HD64F3437TF16 Datasheet, PDF (120/752 Pages) Hitachi Semiconductor – 12 V must not be applied to the S-mask model (single-power-supply specification), as this may permanently damage the device.

6.2 Oscillator Circuit
6.2.1 Oscillator (Generic Device)
If an external crystal is connected across the EXTAL and XTAL pins, the on-chip oscillator circuit
generates a system clock signal. Alternatively, an external clock signal can be applied to the
EXTAL pin.
Connecting an External Crystal
Circuit Configuration: An external crystal can be connected as in the example in figure 6.2.
Table 6.1 indicates the appropriate damping resistance Rd. An AT-cut parallel resonance crystal
should be used.
C_L1
EXTAL
XTAL
Rd
C_L2
C_L1 = C _L2 = 10 pF to 22 pF
Figure 6.2 Connection of Crystal Oscillator (Example)
Table 6.1 Damping Resistance
Frequency (MHz)
Rd max (Ω)
2
4
8
10
12
16
1k
500
200
0
0
0
Crystal Oscillator: Figure 6.3 shows an equivalent circuit of the crystal resonator. The crystal
resonator should have the characteristics listed in table 6.2.
91