HD64F3437TF16 Datasheet, PDF (255/752 Pages) Hitachi Semiconductor – 12 V must not be applied to the S-mask model (single-power-supply specification), as this may permanently damage the device.

11.2.3 System Control Register (SYSCR)
Bit
Initial value
Read/Write
7
SSBY
0
R/W
6
STS2
0
R/W
5
STS1
0
R/W
4
STS0
0
R/W
3
2
1
XRST NMIEG HIE
1
0
0
R
R/W
R/W
0
RAME
1
R/W
Only bit 3 is described here. For details of other bits, see section 3.2., System Control Register
(SYSCR), and descriptions of the relevant modules.
Bit 3—External Reset (XRST): Indicates the reset source. When the watchdog timer is used, a
reset can be generated by watchdog timer overflow as well as by external reset input.
XRST is a read-only bit. It is set to 1 by an external reset and cleared to 0 by an internal reset due
to watchdog timer overflow when the RST/NMI bit is 1.
Bit 3: XRST
0
1
Description
A reset is generated by an internal reset due to watchdog timer overflow
A reset is generated by external reset input
(Initial value)
11.2.4 Register Access
The watchdog timer’s TCNT and TCSR registers are more difficult to write to than other registers.
The procedures for writing and reading these registers are given below.
Writing to TCNT and TCSR: Word access is required. Byte data transfer instructions cannot be
used for write access.
The TCNT and TCSR registers have the same write address. The write data must be contained in
the lower byte of a word written at this address. The upper byte must contain H'5A (password for
TCNT) or H'A5 (password for TCSR). See figure 11.2. The result of the access depicted in figure
11.2 is to transfer the write data from the lower byte to TCNT or TCSR.
Writing to TCNT
15
H'FFA8
H'5A
87
0
Write data
Writing to TCSR
15
H'FFA8
H'A5
87
0
Write data
Figure 11.2 Writing to TCNT and TCSR
226