C8051F960-B-GM Datasheet, PDF (447/492 Pages) Silicon Laboratories – Ultra Low Power 128K, LCD MCU Family

C8051F96x
Pre-scaled C lock
SYSCLK
T0
C ro ss b a r
GATE0
CKCON
TTTTTTSS
3 3 2 2 1 0CC
MMMMMMA A
HLHL
10
TMOD
GCT TGCT T
A / 11A / 00
T TMM T TMM
E1 1 0E0 1 0
1
0
0
0
1
1
IT 0 1 C F
IIIIIIII
NNNNNNNN
11110000
PSSSPSSS
LLLLLLLL
210 210
TR0
TCLK
TL0
(5 bits)
TH0
(8 bits)
TF1
TR1
TF0
TR0
IE 1
IT 1
IE 0
IT 0
Interrupt
IN T 0
IN 0PL _XOR
Figure 32.1. T0 Mode 0 Block Diagram
32.1.2. Mode 1: 16-bit Counter/Timer
Mode 1 operation is the same as Mode 0, except that the counter/timer registers use all 16 bits. The
counter/timers are enabled and configured in Mode 1 in the same manner as for Mode 0.
32.1.3. Mode 2: 8-bit Counter/Timer with Auto-Reload
Mode 2 configures Timer 0 and Timer 1 to operate as 8-bit counter/timers with automatic reload of the start
value. TL0 holds the count and TH0 holds the reload value. When the counter in TL0 overflows from all
ones to 0x00, the timer overflow flag TF0 (TCON.5) is set and the counter in TL0 is reloaded from TH0. If
Timer 0 interrupts are enabled, an interrupt will occur when the TF0 flag is set. The reload value in TH0 is
not changed. TL0 must be initialized to the desired value before enabling the timer for the first count to be
correct. When in Mode 2, Timer 1 operates identically to Timer 0.
Both counter/timers are enabled and configured in Mode 2 in the same manner as Mode 0. Setting the
TR0 bit (TCON.4) enables the timer when either GATE0 (TMOD.3) is logic 0 or when the input signal INT0
is active as defined by bit IN0PL in register IT01CF (see Section “17.6. External Interrupts INT0 and INT1”
on page 242 for details on the external input signals INT0 and INT1).
Rev. 1.0
447