C8051F960-B-GM Datasheet, PDF (30/492 Pages) Silicon Laboratories – Ultra Low Power 128K, LCD MCU Family

C8051F96x
1.3. Serial Ports
The C8051F96x Family includes an SMBus/I²C interface, a full-duplex UART with enhanced baud rate
configuration, and two Enhanced SPI interfaces. Each of the serial buses is fully implemented in hardware
and makes extensive use of the CIP-51's interrupts, thus requiring very little CPU intervention.
1.4. Programmable Counter Array
An on-chip Programmable Counter/Timer Array (PCA) is included in addition to the four 16-bit general pur-
pose counter/timers. The PCA consists of a dedicated 16-bit counter/timer time base with six programma-
ble capture/compare modules. The PCA clock is derived from one of six sources: the system clock divided
by 12, the system clock divided by 4, Timer 0 overflows, an External Clock Input (ECI), the system clock, or
the external oscillator clock source divided by 8.
Each capture/compare module can be configured to operate in a variety of modes: edge-triggered capture,
software timer, high-speed output, pulse width modulator (8, 9, 10, 11, or 16-bit), or frequency output. Addi-
tionally, Capture/Compare Module 5 offers watchdog timer (WDT) capabilities. Following a system reset,
Module 5 is configured and enabled in WDT mode. The PCA Capture/Compare Module I/O and External
Clock Input may be routed to Port I/O via the Digital Crossbar.
SYSCLK /12
SYSCLK /4
Timer0 Overflow
ECI
SYSCLK
PCA
CLOCK
MUX
External Clock/8
16 -Bit Counter/Timer
Capture/ Compare
Module 0
Capture/ Compare
Module 1
Capture/ Compare
Module 2
Capture/ Compare
Module 3
Capture/ Compare
Module 4
Capture/ Compare
Module5 / WDT
Crossbar
Port I/O
Figure 1.12. PCA Block Diagram
30
Rev. 1.0