Z8F1680SH020SG Datasheet, PDF (377/412 Pages) Zilog, Inc. – High-Performance 8-Bit Microcontrollers

Z8 Encore! XP^® F1680 Series
Product Specification
352
The currents in Table 190 represent the power consumption without any peripherals active
(unless otherwise noted). For design guidance, total power consumption will be the sum of
all active peripheral currents plus the appropriate current characteristics shown below.
Table 190. Supply Current Characteristics
Symbol Parameter
I_DDA1
Active Mode Device
Current Executing from
Flash
I_DDA2
Active Mode Device
Current Executing from
PRAM
I_DDH Halt Mode Device Current
T_A = 0° C to +70° C
T_A = –40° C to +105° C
Min Typical¹ Max
Units
8.5
mA
Conditions²
Typical: 20 MHz^{3, 4, 5, 6}, 
V_DD = 3 V, Flash, 25° C
6
mA
Typical: 20 MHz^{3, 4, 5, 6}, 
V_DD = 3 V, PRAM, 25° C
TBD
mA
Typical: 20 MHz^{3, 4, 5}, V_DD
typical, 25° C
I_DDS1 Stop Mode Device Current
2.5
Typical: WDT, V_DD typical,
µA 25 °C, all peripherals
including VBO disabled^{3, 4, 6}
I_DDS2 Stop Mode Device Current
<1
Typical: V_DD typical, 25° C,
µA
all peripherals disabled
including VBO and 
WDT^{3, 4, 6}
Notes
1. These values are provided for design guidance only and are not tested in production.
2. Typical conditions are defined as 3.3 V at 25°C, unless otherwise noted.
3. All internal pull ups are disabled and all push-pull outputs are unloaded.
4. All open-drain outputs are pulled up to V_DD/AV_DD and are at a High state.
5. System clock source is an external square wave clock signal driven through the CLK-IN pin.
6. All inputs are at V_DD/AV_DD or V_SS/AV_SS as appropriate.
PS025015-1212
PRELIMINARY
Electrical Characteristics