SH7125_08 Datasheet, PDF (570/774 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family

Section 15 Pin Function Controller (PFC)
15.2 Usage Notes
1. In this LSI, the same function is available as a multiplexed function on multiple pins. This
approach is intended to increase the number of selectable pin functions and to allow the easier
design of boards. If two or more pins are specified for one function, however, there are two
cautions shown below.
 When the pin function is input
Signals input to several pins are formed as one signal through OR or AND logic and the
signal is transmitted into the LSI. Therefore, a signal that differs from the input signals may
be transmitted to the LSI depending on the input signals in other pins that have the same
functions. Table 15.6 shows the transmit forms of input functions allocated to several pins.
When using one of the functions shown below in multiple pins, use it with care of signal
polarity considering the transmit forms.
Table 15.6 Transmit Forms of Input Functions Allocated to Multiple Pins
OR Type
AND Type
SCK0 to SCK2, RXD0 to RXD2, POE0, POE1, IRQ0* to IRQ3
POE3*, POE8
Note: * This pin is supported only by the SH7125.
OR type: Signals input to several pins are formed as one signal through OR logic and the
signal is transmitted into the LSI.
AND type: Signals input to several pins are formed as one signal through AND logic and
the signal is transmitted into the LSI.
 When the pin function is output
Each selected pin can output the same function.
2. When the port input is switched from a low level to the IRQ edge for the pins that are
multiplexed with input/output and IRQ, the corresponding edge is detected.
3. Do not set functions other than those specified in tables 15.3 and 15.4. Otherwise, correct
operation cannot be guaranteed.
Rev. 4.00 Jul. 25, 2008 Page 550 of 750
REJ09B0243-0400