HD6473032F16 Datasheet, PDF (653/847 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series

20.3 Sleep Mode
Section 20 Power-Down State
20.3.1 Transition to Sleep Mode
When the SSBY bit is cleared to 0 in SYSCR, execution of the SLEEP instruction causes a
transition from the program execution state to sleep mode. Immediately after executing the SLEEP
instruction the CPU halts, but the contents of its internal registers are retained. The DMA
controller (DMAC), refresh controller, and on-chip supporting modules do not halt in sleep mode.
Modules which have been placed in standby by the module standby function, however, remain
halted.
20.3.2 Exit from Sleep Mode
Sleep mode is exited by an interrupt, or by input at the RES or STBY pin.
Exit by Interrupt: An interrupt terminates sleep mode and causes a transition to the interrupt
exception handling state. Sleep mode is not exited by an interrupt source in an on-chip supporting
module if the interrupt is disabled in the on-chip supporting module. Sleep mode is not exited by
an interrupt other than NMI if the interrupt is masked by the I and UI bits in CCR and IPR.
Exit by RES Input: Low input at the RES pin exits from sleep mode to the reset state.
Exit by STBY Input: Low input at the STBY pin exits from sleep mode to hardware standby
mode.
Rev. 3.00 Mar 21, 2006 page 623 of 814
REJ09B0302-0300