HD6473032F16 Datasheet, PDF (266/847 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series

Section 8 DMA Controller
8.4.12 Aborting a DMA Transfer
When the DTE bit in an active channel is cleared to 0, the DMAC halts after transferring the
current byte or word. The DMAC starts again when the DTE bit is set to 1. In full address mode,
the DTME bit can be used for the same purpose. Figure 8.22 shows the procedure for aborting a
DMA transfer by software.
DMA transfer abort
Set DTCR
1. Clear the DTE bit to 0 in DTCR.
To avoid generating an interrupt
when aborting a DMA transfer,
clear the DTIE bit to 0
simultaneously.
1
DMA transfer aborted
Figure 8.22 Procedure for Aborting a DMA Transfer
Rev. 3.00 Mar 21, 2006 page 236 of 814
REJ09B0302-0300