HD6473032F16 Datasheet, PDF (240/847 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series

Section 8 DMA Controller
For the detailed settings see section 8.2.4, Data Transfer Control Registers (DTCR).
Figure 8.3 shows a sample setup procedure for I/O mode.
I/O mode setup
Set source and
destination addresses
1
Set transfer count
2
Read DTCR
3
Set DTCR
4
I/O mode
1. Set the source and destination addresses
in MAR and IOAR. The transfer direction
is determined automatically from the
activation source.
2. Set the transfer count in ETCR.
3. Read DTCR while the DTE bit is cleared
to 0.
4. Set the DTCR bits as follows.
• Select the DMAC activation source
with bits DTS2 to DTS0.
• Set or clear the DTIE bit to enable or
disable the CPU interrupt at the end of
the transfer.
• Clear the RPE bit to 0 to select I/O
mode.
• Select MAR increment or decrement
with the DTID bit.
• Select byte size or word size with the
DTSZ bit.
• Set the DTE bit to 1 to enable the
transfer.
Figure 8.3 I/O Mode Setup Procedure (Example)
8.4.3 Idle Mode
Idle mode can be selected independently for each channel.
One byte or word is transferred at each transfer request in idle mode. A designated number of
these transfers are executed. One address is specified in the memory address register (MAR), the
other in the I/O address register (IOAR). The direction of transfer is determined automatically
from the activation source. The transfer is from the address specified in IOAR to the address
specified in MAR if activated by an SCI channel 0 receive-data-full interrupt, and from the
address specified in MAR to the address specified in IOAR otherwise.
Table 8.7 indicates the register functions in idle mode.
Rev. 3.00 Mar 21, 2006 page 210 of 814
REJ09B0302-0300