C8051F93X Datasheet, PDF (310/330 Pages) Silicon Laboratories – Pipelined intstruction architecture executes 70 of instruction in 1 or 2 system clocks

C8051F93x-C8051F92x
26.3.2. Software Timer (Compare) Mode
In Software Timer mode, the PCA counter/timer value is compared to the module's 16-bit capture/compare
register (PCA0CPHn and PCA0CPLn). When a match occurs, the Capture/Compare Flag (CCFn) in
PCA0CN is set to logic 1. An interrupt request is generated if the CCFn interrupt for that module is
enabled. The CCFn bit is not automatically cleared by hardware when the CPU vectors to the interrupt
service routine, and must be cleared by software. Setting the ECOMn and MATn bits in the PCA0CPMn
register enables Software Timer mode.
Important Note About Capture/Compare Registers: When writing a 16-bit value to the PCA0
Capture/Compare registers, the low byte should always be written first. Writing to PCA0CPLn clears the
ECOMn bit to 0; writing to PCA0CPHn sets ECOMn to 1.
Write to
PCA0CPLn
0
Reset
ENB
Write to
PCA0CPHn ^ENB
1
PCA0CPMn
P ECCMT P E
WCA A AOWC
MOP P TGMC
1 MPN n n n F
6nnn
n
n
x 00 00x
Enable
PCA0CPLn PCA0CPHn
PCA Interrupt
PCA0CN
CC
CCC
FR
CCC
FFF
210
16-bit Comparator
Match
0
1
PCA
Timebase
PCA0L
PCA0H
Figure 26.5. PCA Software Timer Mode Diagram
310
Rev. 1.3