C8051F93X Datasheet, PDF (296/330 Pages) Silicon Laboratories – Pipelined intstruction architecture executes 70 of instruction in 1 or 2 system clocks

C8051F93x-C8051F92x
SFR Definition 25.8. TMR2CN: Timer 2 Control
Bit
7
6
5
4
3
2
1
0
Name
Type
Reset
TF2H
R/W
0
TF2L
TF2LEN TF2CEN T2SPLIT
TR2
R/W
R/W
R/W
R/W
R/W
0
0
0
0
0
T2XCLK[1:0]
R/W
0
0
SFR Page = 0x0; SFR Address = 0xC8; Bit-Addressable
Bit
Name
Function
7
TF2H
Timer 2 High Byte Overflow Flag.
Set by hardware when the Timer 2 high byte overflows from 0xFF to 0x00. In 16 bit
mode, this will occur when Timer 2 overflows from 0xFFFF to 0x0000. When the
Timer 2 interrupt is enabled, setting this bit causes the CPU to vector to the
Timer 2 interrupt service routine. This bit is not automatically cleared by hardware.
6
TF2L
Timer 2 Low Byte Overflow Flag.
Set by hardware when the Timer 2 low byte overflows from 0xFF to 0x00. TF2L will
be set when the low byte overflows regardless of the Timer 2 mode. This bit is not
automatically cleared by hardware.
5
TF2LEN Timer 2 Low Byte Interrupt Enable.
When set to 1, this bit enables Timer 2 Low Byte interrupts. If Timer 2 interrupts
are also enabled, an interrupt will be generated when the low byte of Timer 2 over-
flows.
4
TF2CEN Timer 2 Capture Enable.
When set to 1, this bit enables Timer 2 Capture Mode.
3
T2SPLIT Timer 2 Split Mode Enable.
When set to 1, Timer 2 operates as two 8-bit timers with auto-reload. Otherwise,
Timer 2 operates in 16-bit auto-reload mode.
2
TR2
Timer 2 Run Control.
Timer 2 is enabled by setting this bit to 1. In 8-bit mode, this bit enables/disables
TMR2H only; TMR2L is always enabled in split mode.
1:0 T2XCLK[1:0] Timer 2 External Clock Select.
This bit selects the “external” and “capture trigger” clock sources for Timer 2. If
Timer 2 is in 8-bit mode, this bit selects the “external” clock source for both timer
bytes. Timer 2 Clock Select bits (T2MH and T2ML in register CKCON) may still be
used to select between the “external” clock and the system clock for either timer.
Note: External clock sources are synchronized with the system clock.
00: External Clock is SYSCLK/12. Capture trigger is SmaRTClock/8.
01: External Clock is Comparator 0. Capture trigger is SmaRTClock/8.
10: External Clock is SYSCLK/12. Capture trigger is Comparator 0.
11: External Clock is SmaRTClock/8. Capture trigger is Comparator 0.
296
Rev. 1.3