C8051F93X Datasheet, PDF (147/330 Pages) Silicon Laboratories – Pipelined intstruction architecture executes 70 of instruction in 1 or 2 system clocks

C8051F93x-C8051F92x
SFR Definition 12.7. IT01CF: INT0/INT1 Configuration
Bit
7
6
5
4
3
2
1
0
Name IN1PL
IN1SL[2:0]
IN0PL
IN0SL[2:0]
Type R/W
R/W
R/W
R/W
Reset
0
0
0
0
0
0
0
1
SFR Page = 0x0; SFR Address = 0xE4
Bit Name
Function
7
IN1PL INT1 Polarity.
0: INT1 input is active low.
1: INT1 input is active high.
6:4 IN1SL[2:0] INT1 Port Pin Selection Bits.
These bits select which Port pin is assigned to INT1. Note that this pin assignment is
independent of the Crossbar; INT1 will monitor the assigned Port pin without disturb-
ing the peripheral that has been assigned the Port pin via the Crossbar. The Crossbar
will not assign the Port pin to a peripheral if it is configured to skip the selected pin.
000: Select P0.0
001: Select P0.1
010: Select P0.2
011: Select P0.3
100: Select P0.4
101: Select P0.5
110: Select P0.6
111: Select P0.7
3
IN0PL INT0 Polarity.
0: INT0 input is active low.
1: INT0 input is active high.
2:0 IN0SL[2:0] INT0 Port Pin Selection Bits.
These bits select which Port pin is assigned to INT0. Note that this pin assignment is
independent of the Crossbar; INT0 will monitor the assigned Port pin without disturb-
ing the peripheral that has been assigned the Port pin via the Crossbar. The Crossbar
will not assign the Port pin to a peripheral if it is configured to skip the selected pin.
000: Select P0.0
001: Select P0.1
010: Select P0.2
011: Select P0.3
100: Select P0.4
101: Select P0.5
110: Select P0.6
111: Select P0.7
Rev. 1.3
147