C8051F93X Datasheet, PDF (289/330 Pages) Silicon Laboratories – Pipelined intstruction architecture executes 70 of instruction in 1 or 2 system clocks

C8051F93x-C8051F92x
SFR Definition 25.2. TCON: Timer Control
Bit
7
6
5
4
3
2
1
0
Name ^TF1
TR1
TF0
TR0
IE1
IT1
IE0
IT0
Type
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset
0
0
0
0
0
0
0
0
SFR Page = 0x0; SFR Address = 0x88; Bit-Addressable
Bit Name
Function
7
TF1
Timer 1 Overflow Flag.
Set to 1 by hardware when Timer 1 overflows. This flag can be cleared by software
but is automatically cleared when the CPU vectors to the Timer 1 interrupt service
routine.
6
TR1
Timer 1 Run Control.
Timer 1 is enabled by setting this bit to 1.
5
TF0
Timer 0 Overflow Flag.
Set to 1 by hardware when Timer 0 overflows. This flag can be cleared by software
but is automatically cleared when the CPU vectors to the Timer 0 interrupt service
routine.
4
TR0
Timer 0 Run Control.
Timer 0 is enabled by setting this bit to 1.
3
IE1
External Interrupt 1.
This flag is set by hardware when an edge/level of type defined by IT1 is detected. It
can be cleared by software but is automatically cleared when the CPU vectors to the
External Interrupt 1 service routine in edge-triggered mode.
2
IT1
Interrupt 1 Type Select.
This bit selects whether the configured INT1 interrupt will be edge or level sensitive.
INT1 is configured active low or high by the IN1PL bit in the IT01CF register (see
SFR Definition 12.7).
0: INT1 is level triggered.
1: INT1 is edge triggered.
1
IE0
External Interrupt 0.
This flag is set by hardware when an edge/level of type defined by IT1 is detected. It
can be cleared by software but is automatically cleared when the CPU vectors to the
External Interrupt 0 service routine in edge-triggered mode.
0
IT0
Interrupt 0 Type Select.
This bit selects whether the configured INT0 interrupt will be edge or level sensitive.
INT0 is configured active low or high by the IN0PL bit in register IT01CF (see SFR
Definition 12.7).
0: INT0 is level triggered.
1: INT0 is edge triggered.
Rev. 1.3
289