HD64F3028F25 Datasheet, PDF (642/925 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series

setting the P or E bit in FLMCR. However, PV and EV bit setting is enabled, and a transition can
be made to verify mode*².
FLER bit setting conditions are as follows:
1. When flash memory is read during programming/erasing (including a vector read or instruction
fetch)
2. Immediately after the start of exception handling during programming/erasing (excluding
reset, illegal instruction, trap instruction, and division-by-zero exception handling)
3. When a SLEEP instruction (including software standby) is executed during
programming/erasing
4. When the bus is released during programming/erasing
Error protection is released only by a RES pin or WDT reset, or in hardware standby mode.
Notes: 1. State in which the P bit or E bit in FLMCR1 is set to 1. Note that NMI input is disabled
in this state.
2. It is possible to perform a program-verify operation on the 128 bytes being
programmed, or an erase-verify on the block being erased.
3. FLMCR1, EBR1, and EBR2 can be written to. However, the registers are initialized if
a transition is made to software standby mode while in the error protection state.
Figure 18.12 shows the flash memory state transition diagram.
Rev. 2.00, 09/03, page 610 of 890