HD64F3028F25 Datasheet, PDF (383/925 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series

Sample Setup Procedure for PWM Mode: Figure 9.26 shows a sample procedure for setting up
PWM mode.
PWM mode
Select counter clock
1. Set bits TPSC2 to TPSC0 in 16TCR to
select the counter clock source. If an
external clock source is selected, set
bits CKEG1 and CKEG0 in 16TCR to
1
select the desired edge(s) of the
external clock signal.
2. Set bits CCLR1 and CCLR0 in 16TCR
Select counter clear source
2
to select the counter clear source.
3. Set the time at which the PWM
waveform should go to 1 in GRA.
Set GRA
3
4. Set the time at which the PWM
waveform should go to 0 in GRB.
Set GRB
Select PWM mode
Start counter
5. Set the PWM bit in TMDR to select
4
PWM mode. When PWM mode is
selected, regardless of the TIOR
contents, GRA and GRB become
output compare registers specifying
5
the times at which the PWM output
goes to 1 and 0. The TIOCA pin
automatically becomes the PWM
output pin. The TIOCB pin conforms
6
to the settings of bits IOB1 and IOB0
in TIOR. If TIOCB output is not
desired, clear both IOB1 and IOB0 to 0.
PWM mode
6. Set the STR bit to 1 in TSTR to start
the timer counter.
Figure 9.26 Setup Procedure for PWM Mode (Example)
Rev. 2.00, 09/03, page 351 of 890