HD6413008VF25 Datasheet, PDF (350/688 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

10. Programmable Timing Pattern Controller (TPC)
10.3.4 Non-Overlapping TPC Output
Sample Setup Procedure for Non-Overlapping TPC Output: Figure 10.6 shows a sample
procedure for setting up non-overlapping TPC output.
16-bit timer
setup
Port and
TPC setup
16-bit timer
setup
Non-overlapping
TPC output
Select GR functions
1
Set GR values
2
Select counting operation
3
Select interrupt requests
4
Set initial output data
5
Set up TPC output
6
Enable TPC transfer
7
Select TPC transfer trigger
8
Select non-overlapping groups 9
Set next TPC output data
10
Start counter
11
No
Compare match A?
Yes
Set next TPC output data
12
1. Set TIOR to make GRA and GRB output
compare registers (with output inhibited).
2. Set the TPC output trigger period in GRB
and the non-overlap margin in GRA.
3. Select the counter clock source with bits
TPSC2 to TPSC0 in TCR. Select the counter
clear source with bits CCLR1 and CCLR0.
4. Enable the IMFA interrupt in TISRA.
5. Set the initial output values in the DR bits
of the input/output port pins to be used for
TPC output.
6. Set the DDR bits of the input/output port pins
to be used for TPC output to 1.
7. Set the NDER bits of the pins to be used for
TPC output to 1.
8. In TPCR, select the 16-bit timer compare
match event to be used as the TPC output
trigger.
9. In TPMR, select the groups that will operate
in non-overlap mode.
10. Set the next TPC output values in the NDR
bits.
11. Set the STR bit to 1 in TSTR to start the timer
counter.
12. At each IMFA interrupt, write the next output
value in the NDR bits.
Figure 10.6 Setup Procedure for Non-Overlapping TPC Output (Example)
Rev.4.00 Aug. 20, 2007 Page 304 of 638
REJ09B0395-0400