HD64F38024HV Datasheet, PDF (504/684 Pages) Renesas Technology Corp – Hardware Manual Renesas 8-Bit Single-Chip Microcomputer H8 Family/H8/300L Super Low Power Series

Section 16 Electrical Characteristics
Notes: 1. Make the time settings in accordance with the program/erase algorithms.
2. The programming time for 128 bytes. (Indicates the total time for which the P bit in
flash memory control register 1 (FLMCR1) is set. The program-verify time is not
included.)
3. The time required to erase one block. (Indicates the time for which the E bit in flash
memory control register 1 (FLMCR1) is set. The erase-verify time is not included.)
4. Programming time maximum value (tP(MAX)) = wait time after P bit setting (z) ×
maximum number of writes (N)
5. Set the maximum number of writes (N) according to the actual set values of z1, z2,
and z3, so that it does not exceed the programming time maximum value (tP(MAX)).
The wait time after P bit setting (z1, z2) should be changed as follows according to the
value of the number of writes (n).
Number of writes (n)
1≤n≤6
z1 = 30 µs
7 ≤ n ≤ 1000 z2 = 200 µs
6. Erase time maximum value (tE(max)) = wait time after E bit setting (z) × maximum
number of erases (N)
7. Set the maximum number of erases (N) according to the actual set value of (z), so that
it does not exceed the erase time maximum value (tE(max)).
8. The minimum number of times all characteristics are guaranteed following
reprogramming. (The guarantee covers the range from 1 to the minimum value.)
9. Reference value at 25°C. (Guideline showing number of reprogrammings over which
functioning will be retained under normal circumstances.)
10. Data retention characteristics within the range indicated in the specifications, including
the minimum value for reprogrammings.
11. Applies to an operating voltage range when reading data of 3.0 to 3.6 V.
12. Applies to an operating voltage range when reading data of 2.7 to 3.6 V.
16.4.7 Power Supply Characteristics
Table 16.14 Power Supply Characteristics
Unless otherwise indicated, V_CC = 2.7 V to 3.6 V, AV_CC = 2.7 V to 3.6 V, V_SS = AV_SS = 0.0 V
Item
Applicable Test
Symbol Pins
Condition Min
Values
Typ Max Unit
Notes
Power supply startup voltage VCCSTART VCC
0
— 0.1 V
*¹*²
Power supply startup slope SVCC
VCC
0.05 — — V/ms
Notes: 1. This LSI may not start normally when it starts with the condition beyond specification
shown in above (Refer to figure 16.1 for power supply voltage startup time.).
2. Applies to the F-ZTAT version.
Rev. 8.00 Mar. 09, 2010 Page 482 of 658
REJ09B0042-0800