HD64F38024HV Datasheet, PDF (368/684 Pages) Renesas Technology Corp – Hardware Manual Renesas 8-Bit Single-Chip Microcomputer H8 Family/H8/300L Super Low Power Series

Section 10 Serial Communication Interface
10.2.7 Serial Status Register (SSR)
Bit
Initial value
Read/Write
7
TDRE
1
R/(W)^*
6
RDRF
0
R/(W)^*
5
OER
0
R/(W)^*
4
FER
0
R/(W)^*
3
PER
0
R/(W)^*
2
TEND
1
R
1
MPBR
0
R
0
MPBT
0
R/W
Note: * Only a write of 0 for flag clearing is possible.
SSR is an 8-bit register containing status flags that indicate the operational status of SCI3.
SSR can be read or written to by the CPU at any time, but 1 cannot be written to bits TDRE,
RDRF, OER, PER, and FER.
Bits TEND and MPBR are read-only bits, and cannot be modified.
SSR is initialized to H'84 upon reset, and in standby, module standby, or watch mode.
Bit 7—Transmit Data Register Empty (TDRE)
Bit 7 indicates that transmit data has been transferred from TDR to TSR.
Bit 7
TDRE
0
1
Description
Transmit data written in TDR has not been transferred to TSR
Clearing conditions:
After reading TDRE = 1, cleared by writing 0 to TDRE
When data is written to TDR by an instruction
Transmit data has not been written to TDR, or transmit data written in
TDR has been transferred to TSR
Setting conditions:
When bit TE in SCR3 is cleared to 0
When data is transferred from TDR to TSR
(initial value)
Rev. 8.00 Mar. 09, 2010 Page 346 of 658
REJ09B0042-0800