HD64F38024HV Datasheet, PDF (320/684 Pages) Renesas Technology Corp – Hardware Manual Renesas 8-Bit Single-Chip Microcomputer H8 Family/H8/300L Super Low Power Series

Section 9 Timers
Clock Levels Before and After
No. Modifying Bits CKS1 and CKS0
3
Goes from high level to low level
TCG Operation
Clock before
switching
Clock after
switching
*
Count
clock
TCG
N
4
Goes from high level to high level
Clock before
switching
Clock after
switching
Count
clock
N+1
N+2
Write to CKS1 and CKS0
TCG
N
N+1
N+2
Note: * The switchover is seen as a falling edge, and TCG is incremented.
Write to CKS1 and CKS0
Notes on Port Mode Register Modification
The following points should be noted when a port mode register is modified to switch the input
capture function or the input capture input noise canceler function.
• Switching input capture input pin function
Note that when the pin function is switched by modifying TMIG in port mode register 1
(PMR1), which performs input capture input pin control, an edge will be regarded as having
been input at the pin even though no valid edge has actually been input. Input capture input
signal input edges, and the conditions for their occurrence, are summarized in table 9.14.
Rev. 8.00 Mar. 09, 2010 Page 298 of 658
REJ09B0042-0800