HD64F38024HV Datasheet, PDF (315/684 Pages) Renesas Technology Corp – Hardware Manual Renesas 8-Bit Single-Chip Microcomputer H8 Family/H8/300L Super Low Power Series

Section 9 Timers
b. Interval timer operation
When the TMIG bit in PMR1 is cleared to 0, timer G functions as an interval timer.
Following a reset, TCG starts counting on the φ/64 internal clock. The input clock can be
selected from four internal clock sources by bits CKS1 and CKS0 in TMG. TCG increments
on the selected clock, and when it overflows from H'FF to H'00, the OVFL bit in TMG is set
to 1. If the OVIE bit in TMG is 1 at this time, IRRTG in IRR2 is set to 1, and if the IENTG bit
in IENR2 is 1, timer G sends an interrupt request to the CPU. For details of the interrupt, see
section 3.3, Interrupts.
Count Timing
TCG is incremented by internal clock input. Bits CKS1 and CKS0 in TMG select one of four
internal clock sources (φ/64, φ/32, φ/2, or φw/4) created by dividing the system clock (φ) or watch
clock (φw).
Input Capture Input Timing
a. Without noise cancellation function
For input capture input, dedicated input capture functions are provided for rising and falling
edges.
Figure 9.11 shows the timing for rising/falling edge input capture input.
Input capture
input signal
Input capture
signal F
Input capture
signal R
Figure 9.11 Input Capture Input Timing (without Noise Cancellation Function)
Rev. 8.00 Mar. 09, 2010 Page 293 of 658
REJ09B0042-0800