82583V Datasheet, PDF (370/374 Pages) Intel Corporation – Intel® 82583V GbE Controller

82583V GbE Controller—Board Layout and Schematic Checklists
Section
Integrated Power
Supply
(Option A and B)
Check Items
Provide a 3.3 V dc supply. Use an auxiliary
power supply.
Connect external PNP transistor's base to
CTRL19 and the emitter to the 3.3 V dc
supply. The collector supplies 1.9 V dc. The
connections and transistor parameters are
critical.
Connect external PNP transistor's base to
CTRL10 and the emitter to the 3.3 V dc
supply. The collector supplies 1.05 V dc. The
connections and transistor parameters are
critical. For option B only.
Connect a 5 KΩ resistor from CTRL19 to the
3.3 V dc supply.
Connect a 5 KΩ resistor from CTRL10 to the
3.3 V dc supply. For option B only.
For option A: Connect DIS_REG10 to ground.
For option B: Connect DIS_REG10 to the
3.3 V dc supply.
Ensure that there is at least 10 μF of
capacitance at the emitters of the PNPs.
The 3.3 V dc rail should have at least 25 μF of
capacitance.
The 1.05 V dc and 1.9 V dc rails should have
20-40 μF of capacitance.
Place these to minimize the inductance from
each power pin to the nearest decoupling
capacitor.
Remarks
Auxiliary power is necessary to support wake up from
power down states.
Enable internal 1.05 V dc regulator if it is used.
Place decoupling and bulk capacitors close to 82583V,
with some along every side, using short, wide traces
and large vias. If power is distributed on traces, bulk
capacitors should be used at both ends. If power is
distributed on cards, bulk capacitors should be used at
the connector.
370