HD6433044 Datasheet, PDF (643/867 Pages) Hitachi Semiconductor – Hitachi Single-Chip Microcomputer

19.2 Oscillator Circuit
Clock pulses can be supplied by connecting a crystal resonator, or by input of an external clock
signal.
19.2.1 Connecting a Crystal Resonator
Circuit Configuration: A crystal resonator can be connected as in the example in figure 19-2.
The damping resistance Rd should be selected according to table 19-1. An AT-cut parallel-
resonance crystal should be used.
C _L1
EXTAL
XTAL
Rd
C _L2
C_L1 = C _L2 = 10 pF to 22 pF
Figure 19-2 Connection of Crystal Resonator (Example)
Table 19-1 Damping Resistance Value
Damping Resistance
Value
2
2<f≤4
4<f≤8
Frequency f (MHz)
8 < f ≤ 10 10 < f ≤ 13 13 < f ≤ 16 16 < f ≤ 18
Rd For products 1 k 500
200
0
0
0
0
(Ω) listed below*
HD64F3048 1 k 1 k
500
200
100
0
—
Note: A crystal resonator between 2 MHz and 18 MHz (between 2 MHz and 16 MHz for the flash
memory version) can be used. If the chip is to be operated at less than 2 MHz, the on-chip
frequency divider should be used. (A crystal resonator of less than 2 MHz cannot be used.)
* HD6473048, HD6433048, HD6433047, HD6433045, HD6433044
Crystal Resonator: Figure 19-3 shows an equivalent circuit of the crystal resonator. The crystal
resonator should have the characteristics listed in table 19-2.
634