3069RF-ZTAT Datasheet, PDF (7/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

Main Revisions for this Edition
Item
Page Revisions (See Manual for Details)
5.1.1 Features
83 Description amended
• Seven external interrupt pins
…. For each of IRQ0 to IRQ5, sensing of the falling
edge or level sensing can be selected independently.
5.1.2 Block Diagram
84 Figure 5.1 amended
Figure 5.1 Interrupt Controller Block
Diagram
(Before) IRQ input → (After) IRQ input
5.2.4 IRQ Enable Register (IER)
95 Description amended
(Before) IRQ5 to IRQ0 interrupts → (After) IRQ5 to IRQ0
interrupts request
18.10.1 Serial Communication Interface 650 (2) Device Selection
Specification for Boot Mode
Description amended
 Size (1 byte) : Amount of device-code data
This is fixed to 4
655, (11) New Bit-Rate Selection
656 _{Description amended}
 Number of multiplication ratios (1 byte) : The
number of multiplication ratios to which the device
can be set. Normally the value is two: main
operating frequency and peripheral module
operating frequency. (With this LSI it should be set
to H'01.)
 Multiplication ratio 2 (1 byte):
 Multiplication ratio (1 byte) : The value of the
multiplication ratio (e.g. when the clock
frequency is multiplied by four, the
multiplication ratio will be H'04. Cannot be set
for this LSI.)
Figure 18.27 Programming Sequence 661 • Programming
Figure 18.27 amended
Host
Boot program
Programming selection (H'42, H'43)
Transfer of the
programming
program
Rev. 5.0, 09/04, page iii of xviii