3069RF-ZTAT Datasheet, PDF (254/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

Figure 7.12 shows a sample setup procedure for block transfer mode.
Block transfer mode
Set source address
Set destination address
Set block transfer count
Set block size
Set DTCRB (1)
Set DTCRA (1)
Read DTCRB
Set DTCRB (2)
[1] Set the source address in MARA.
[2] Set the destination address in MARB.
[3] Set the block transfer count in ETCRB.
[1]
[4] Set the block size (number of bytes or words)
in both ETCRAH and ETCRAL.
[5] Set the DTCRB bits as follows.
• Clear the DTME bit to 0.
[2]
• Set the DAID and DAIDE bits to select whether
MARB is incremented, decremented, or held fixed.
• Set or clear the TMS bit to make the block area
[3]
the source or destination.
• Select the DMAC activation source with bits
DTS2B to DTS0B.
[6] Set the DTCRA bits as follows.
[4]
• Clear the DTE to 0.
• Select byte size or word size with the DTSZ bit.
• Set the SAID and SAIDE bits to select whether
[5]
MARA is incremented, decremented, or held fixed.
• Set or clear the DTIE bit to enable or disable the
CPU interrupt at the end of the transfer.
• Set bits DTS2A to DTS0A all to 1 to select
[6]
block transfer mode.
[7] Read DTCRB with DTME cleared to 0.
[8] Set the DTME bit to 1 in DTCRB.
[9] Read DTCRA with DTE cleared to 0.
[7] _{[10] Set the DTE bit to 1 in DTCRA to enable}
the transfer.
[8]
Read DTCRA
[9]
Set DTCRA (2)
[10]
Block transfer mode
Note: Carry out settings 1 to 10 with the DEND interrupt masked in the CPU.
If an NMI interrupt occurs during the setup procedure, it may clear the DTME bit to 0, in
which case the transfer will not start.
Figure 7.12 Block Transfer Mode Setup Procedure (Example)
Rev. 5.0, 09/04, page 232 of 978