3069RF-ZTAT Datasheet, PDF (648/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

Except for MAT switching, the programming procedure is the same as that in user program mode.
The area that can be executed in the steps of the user procedure program (on-chip RAM, user
MAT, and external space) is shown in section 18.10.3, Procedure Program and Storable Area for
Programming Data.
User MAT Erasing in User Boot Mode: For erasing the user MAT in user boot mode, additional
processings made by setting FMATS are required: switching from user-boot-MAT selection state
to user-MAT selection state, and switching back to user-boot-MAT selection state after erasing
completes.
Figure 18.15 shows the procedure for erasing the user MAT in user boot mode.
Start erasing
procedure program
Select on-chip program
to be downloaded
Set FKEY to H'A5 and
set download destination
by FTDAR
Set SCO to 1 and
execute download
Clear FKEY to 0
DPFR=0 ?
No
Yes _{Download error processing}
Set the FPEFEQ and
FUBRA parameters
Initialization
JSR FTDAR setting+32
FPFR=0 ?
No
Yes _{Initialization error processing}
Disable interrupts
and bus master operation
other than CPU
1
User-boot-MAT
selection state
1
Set FMATS to value other
than H'AA to select user MAT
MAT
switchover
Set FKEY to H'5A
Set FEBS parameter
Programming
JSR FTDAR setting+16
FPFR=0 ?
No
Yes Clear FKEY and erasing
error processing
No
Required
block erasing is
completed?
Yes
Clear FKEY to 0
Set FMATS to H'AA to
select user boot MAT
MAT
switchover
End erasing
procedure program
Note: The MAT must be switched by FMATS to perform the
erasing error processing in the user boot MAT.
Figure 18.15 Procedure for Erasing User MAT in User Boot Mode
The difference between the erasing procedures in user program mode and user boot mode depends
on whether the MAT is switched or not as shown in figure 18.15.
Rev. 5.0, 09/04, page 626 of 978