3069RF-ZTAT Datasheet, PDF (209/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

In (a), an idle cycle is not inserted, and a collision occurs in cycle B between the read data from
ROM and the CPU write data. In (b), an idle cycle is inserted, and a data collision is prevented.
φ
Address bus
4,
094
Data bus
Bus cycle A Bus cycle B
T1 T2 T3 T1 T2
φ
Address bus
4,
094
Data bus
Bus cycle A Bus cycle B
T1 T2 T3 Ti T1 T2
Long buffer-off ^Data
time
collision
(a) Idle cycle not inserted
(b) Idle cycle inserted
Figure 6.44 Example of Idle Cycle Operation (2) (ICIS0 = 1)
External Address Space Access Immediately after DRAM Space Access: If a DRAM space
access is followed by a non-DRAM external access when HWR and LWR have been selected as
the UCAS and LCAS output pins by means of the CSEL bit in DRCRB, a T_i cycle is inserted
regardless of the settings of bits ICIS0 and ICIS1 in BCR. Figure 6.45 shows an example of the
operation.
This is done to prevent simultaneous changing of the HWR and LWR signals used as UCAS and
LCAS in DRAM space and CSn for the space in the next cycle, and so avoid an erroneous write to
the external device in the next cycle.
A T_i cycle is not inserted when PB₄ and PB₅ have been selected as the UCAS and LCAS output
pins.
In the case of consecutive DRAM space access precharge cycles (T_p), the ICIS0 bit settings are
invalid. In the case of consecutive reads between different areas, for example, if the second
access is a DRAM access, only a T_p cycle is inserted, and a T_i cycle is not. The timing in this case
is shown in figure 6.46.
Rev. 5.0, 09/04, page 187 of 978