3069RF-ZTAT Datasheet, PDF (459/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

11.4 Usage Notes
11.4.1 Operation of TPC Output Pins
TP₀ to TP₁₅ are multiplexed with 16-bit timer, DMAC, address bus, and other pin functions. When
16-bit timer, DMAC, or address output is enabled, the corresponding pins cannot be used for TPC
output. The data transfer from NDR bits to DR bits takes place, however, regardless of the usage
of the pin.
Pin functions should be changed only under conditions in which the output trigger event will not
occur.
11.4.2 Note on Non-Overlapping Output
During non-overlapping operation, the transfer of NDR bit values to DR bits takes place as
follows.
1. NDR bits are always transferred to DR bits at compare match A.
2. At compare match B, NDR bits are transferred only if their value is 0. Bits are not transferred
if their value is 1.
Figure 11.9 illustrates the non-overlapping TPC output operation.
DDR
Q
NDER
Q
Compare match A
Compare match B
TPC output pin
C
Q DR D
Q NDR D
Figure 11.9 Non-Overlapping TPC Output
Rev. 5.0, 09/04, page 437 of 978