3069RF-ZTAT Datasheet, PDF (273/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

Table 7.14 Address Ranges Specifiable in MAR and IOAR
MAR
IOAR
1-Mbyte Mode
H'00000 to H'FFFFF
(0 to 1048575)
H'FFF00 to H'FFFFF
(1048320 to 1048575)
16-Mbyte Mode
H'000000 to H'FFFFFF
(0 to 16777215)
H'FFFF00 to H'FFFFFF
(16776960 to 16777215)
MAR bits 23 to 20 are ignored in 1-Mbyte mode.
7.6.8 Bus Cycle when Transfer is Aborted
When a transfer is aborted by clearing the DTE bit or suspended by an NMI that clears the DTME
bit, if this halts a channel for which the DMAC has a transfer request pending internally, a dead
cycle may occur. This dead cycle does not update the halted channel’s address register or counter
value. Figure 7.27 shows an example in which an auto-requested transfer in cycle-steal mode on
channel 0 is aborted by clearing the DTE bit in channel 0.
CPU cycle
DMAC cycle
CPU cycle
DMAC
cycle
CPU cycle
T₁ T₂ T_d T₁ T₂ T₁ T₂ T₁ T₂ T₃ T_d T_d T₁ T₂
φ
Address bus
RD
HWR, LWR
DTE bit is
cleared
Figure 7.27 Bus Timing at Abort of DMA Transfer in Cycle-Steal Mode
7.6.9 Transfer Requests by A/D Converter
When the A/D converter is set to scan mode and conversion is performed on more than one
channel, the A/D converter generates a transfer request when all conversions are completed. The
converted data is stored in the appropriate ADDR registers. Block transfer mode and full address
mode should therefore be used to transfer all the conversion results at one time.
Rev. 5.0, 09/04, page 251 of 978