3069RF-ZTAT Datasheet, PDF (25/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

Feature
DMA controller
(DMAC)
16-bit timer,
3 channels
8-bit timer,
4 channels
Programmable
timing pattern
controller (TPC)
Watchdog
timer (WDT),
1 channel
Serial
communication
interface (SCI),
3 channels
Description
Short address mode
• Maximum four channels available
• Selection of I/O mode, idle mode, or repeat mode
• Can be activated by compare match/input capture A interrupts from 16-bit
timer channels 0 to 2, conversion-end interrupts from the A/D converter,
transmit-data-empty and receive-data-full interrupts from the SCI, or external
requests
Full address mode
• Maximum two channels available
• Selection of normal mode or block transfer mode
• Can be activated by compare match/input capture A interrupts from 16-bit
timer channels 0 to 2, conversion-end interrupts from the A/D converter,
external requests, or auto-request
• Three 16-bit timer channels, capable of processing up to six pulse outputs
or six pulse inputs
• 16-bit timer counter (channels 0 to 2)
• Two multiplexed output compare/input capture pins (channels 0 to 2)
• Operation can be synchronized (channels 0 to 2)
• PWM mode available (channels 0 to 2)
• Phase counting mode available (channel 2)
• DMAC can be activated by compare match/input capture A interrupts
(channels 0 to 2)
• 8-bit up-counter (external event count capability)
• Two time constant registers
• Two channels can be connected
• Maximum 16-bit pulse output, using 16-bit timer as time base
• Up to four 4-bit pulse output groups (or one 16-bit group, or two 8-bit
groups)
• Non-overlap mode available
• Output data can be transferred by DMAC
• Reset signal can be generated by overflow
• Usable as an interval timer
• Selection of asynchronous or synchronous mode
• Full duplex: can transmit and receive simultaneously
• On-chip baud-rate generator
• Smart card interface functions added
Rev. 5.0, 09/04, page 3 of 978