3069RF-ZTAT Datasheet, PDF (456/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

11.3.4 Non-Overlapping TPC Output
Sample Setup Procedure for Non-Overlapping TPC Output: Figure 11.6 shows a sample
procedure for setting up non-overlapping TPC output.
16-bit timer
setup
Port and
TPC setup
16-bit timer
setup
Non-overlapping
TPC output
Select GR functions
Set GR values
Select counting operation
Select interrupt requests
Set initial output data
Set up TPC output
Enable TPC transfer
Select TPC transfer trigger
Select non-overlapping groups
Set next TPC output data
Start counter
[1] [1] Set TIOR to make GRA and GRB output
compare registers (with output inhibited).
[2]
[2] Set the TPC output trigger period in GRB
and the non-overlap margin in GRA.
[3] Select the counter clock source with bits
[3]
TPSC2 to TPSC0 in TCR. Select the counter
clear source with bits CCLR1 and CCLR0.
[4] _{[4] Enable the IMFA interrupt in TISRA.}
The DMAC can also be set up to transfer
data to the next data register.
[5]
[5] Set the initial output values in the DR bits
of the input/output port pins to be used for
[6]
TPC output.
[6] Set the DDR bits of the input/output port pins
[7]
to be used for TPC output to 1.
[7] Set the NDER bits of the pins to be used for
TPC output to 1.
[8]
[8] In TPCR, select the 16-bit timer compare match
event to be used as the TPC output trigger.
[9] _{[9] In TPMR, select the groups that will operate}
in non-overlap mode.
[10] Set the next TPC output values in the NDR
[10]
bits.
[11] Set the STR bit to 1 in TSTR to start the timer
counter.
[11] [12] At each IMFA interrupt, write the next output
value in the NDR bits.
Compare match A?
Yes
Set next TPC output data
No
[12]
Figure 11.6 Setup Procedure for Non-Overlapping TPC Output (Example)
Rev. 5.0, 09/04, page 434 of 978