3069RF-ZTAT Datasheet, PDF (602/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

Table 18.2 Comparison of Programming Modes
Boot mode
User program
mode
User boot mode PROM mode
Programming/
Erasing
Environment
On-board
programming
On-board
programming
On-board
programming
Off-board
programming
Programming/
Erasing Enable
MAT
User MAT
User boot MAT
User MAT
User MAT
User MAT
User boot MAT
All Erasure
Block Division
Erasure
(Automatic)
*¹
(Automatic)
×
Program Data
Transfer
From host via
SCI
From optional
device via RAM
From optional
device via RAM
Via programmer
User Branch
×
×
×
×
Function
RAM Emulation
Reset Initiation
MAT
×
Embedded
program storage
MAT
User MAT
×
×
User boot MAT*² —
Transition to
User Mode
Mode setting
FWE setting
change and reset change
Mode setting
—
change and reset
Notes: 1. All-erasure is performed. After that, the specified block can be erased.
2. Initiation starts from the embedded program storage MAT. After checking the flash-
memory related registers, initiation starts from the reset vector of the user MAT.
• The user boot MAT can be programmed or erased only in boot mode and PROM mode.
• The user MAT and user boot MAT are erased in boot mode. Then, the user MAT and user
boot MAT can be programmed by means of the command method. However, the contents of
the MAT cannot be read until this state.
Only user boot MAT is programmed and the user MAT is programmed in user boot mode or
only user MAT is programmed because user boot mode is not used.
• The boot operation of the optional interface can be performed by the mode pin setting
different from user program mode in user boot mode.
Rev. 5.0, 09/04, page 580 of 978