3069RF-ZTAT Datasheet, PDF (206/1003 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER

6.7 Interrupt Sources
Compare match interrupts (CMI) can be generated when the refresh timer is used as an interval
timer. Compare match interrupt requests are masked/unmasked with the CMIE bit in RTMCSR.
6.8 Burst ROM Interface
6.8.1 Overview
With the H8/3069R, external space area 0 can be designated as burst ROM space, and burst ROM
space interfacing can be performed. The burst ROM space interface enables 16-bit organization
ROM with burst access capability to be accessed at high speed. Area 0 is designated as burst
ROM space by means of the BROME bit in BCR.
Continuous burst access of a maximum or four or eight words can be performed on external space
area 0. Two or three states can be selected for burst access.
6.8.2 Basic Timing
The number of states in the initial cycle (full access) and a burst cycle of the burst ROM interface
is determined by the setting of the AST0 bit in ASTCR. When the AST0 bit is set to 1, wait states
can also be inserted in the initial cycle. Wait states cannot be inserted in a burst cycle.
Burst access of up to four words is performed when the BRSTS0 bit is cleared to 0 in BCR, and
burst access of up to eight words when the BRSTS0 bit is set to 1. The number of burst access
states is two when the BRSTS1 bit is cleared to 0, and three when the BRSTS1 bit is set to 1.
The basic access timing for burst ROM space is shown in figure 6.42.
Rev. 5.0, 09/04, page 184 of 978