DRA790 Datasheet, PDF (385/436 Pages) Texas Instruments – Infotainment Applications Processor

www.ti.com
• Propagation delays and matching:
– A to C = C to D = E to F.
– Matching skew: < 60pS
– A to B < 450pS
– B to C = as small as possible (<60pS)
A
R1
0 Ω*
qspi1_sclk
D
DRA790, DRA791
DRA793, DRA797
SPRS968A – AUGUST 2016 – REVISED FEBRUARY 2017
Locate both R2 resistors
close together near the QSPI device
B
C
R2
10 Ω
R2
10 Ω
QSPI device
clock input
qspi1_rtclk
E
F
qspi1_d[x], qspi1_cs[y]
QSPI device
IOx, CS#
SPRS906_PCB_QSPI_01
Figure 7-20. QSPI Interface High Level Schematic
NOTE
*0 Ω resistor (R1), located as close as possible to the qspi1_sclk pin, is placeholder for fine-
tuning if needed.
7.5 Differential Interfaces
7.5.1 General Routing Guidelines
To maximize signal integrity, proper routing techniques for differential signals are important for high-speed
designs. The following general routing guidelines describe the routing guidelines for differential lanes and
differential signals.
• As much as possible, no other high-frequency signals must be routed in close proximity to the
differential pair.
• Must be routed as differential traces on the same layer. The trace width and spacing must be chosen
to yield the differential impedance value recommended.
• Minimize external components on differential lanes (like external ESD, probe points).
• Through-hole pins are not recommended.
• Differential lanes mustn’t cross image planes (ground planes).
• No sharp bend on differential lanes.
Copyright © 2016–2017, Texas Instruments Incorporated
Applications, Implementation, and Layout 385
Submit Documentation Feedback
Product Folder Links: DRA790 DRA791 DRA793 DRA797