S912XHY128F0VLM Datasheet, PDF(727/802 Page) Freescale Semiconductor, Inc – S12 Microcontrollers

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

S912XHY128F0VLM Datasheet, PDF (727/802 Pages) Freescale Semiconductor, Inc – S12 Microcontrollers

◁

Electrical Characteristics

Table A-7 shows the conï¬guration of the peripherals for typical run current.

Table A-7. Module Conï¬gurations for Typical Run Supply (VDDR+VDDA) Current VDD35=5V

Peripheral

Conï¬guration

S12XCPU

COP & RTI

PLL

DBG

CAN0,CAN1

SPI

SCI0,SCI1

PWM

IIC

LCD

420 cycle loop: 384 DBNE cycles plus subroutine entry to stimulate stacking (RAM access)

enabled. COP running at the rate 224, RTI control register(RTICTL) set to $7F

enabled and conï¬gured to supply the part with the maximum speciï¬ed bus frequency (80 MHz).

the module is enabled and the comparators are conï¬gured to trigger in outside range.The range

covers all the code executed by the core,the tracing is disabled..

Conï¬gured to loop-back mode using a bit rate of 500kbit/s

Conï¬gured to master mode, continuously transmit data (0x55 or 0xAA) at 1Mbit/s

Conï¬gured into loop mode, with the break detection and collision detection features enabled,

continuously transmit data (0x55) at speed of 19200 baud

Conï¬gured to toggle its pins at the rate of 1kHz

operate in master mode and continuously transimit data(0x55 or 0xAA) at 100Kbits/s

conï¬gured to 244Hz frame frequency, 1/4 Duty, 1/3 Bias with all FP/BP enabled and all

segment on

MC

conï¬gured to full H-bridge mode MCPER=0x3FF, 1/2fbus motor controller timer counter

clock, MCDC=0x20

SSD

disabled

TIM0,TIM1

ATD

Overhead

The peripheral shall be conï¬gured in output compare mode. Pulse accumulator and modulus

counter enabled.

The peripheral is conï¬gured to operate at its maximum speciï¬ed

frequency and to continuously convert voltages on all input channels in sequence.

VREG supplying 1.8V from a 5V input voltage, PLL on

A.1.10.2 Maximum Run Current Measurement Conditions

Run current is measured on VDDR and VDDA pin. It does not include the current to drive external

loads.Currents are measured in single chip mode, S12XCPU with VDD35=5.5V, internal voltage regulator

enabled and a 40MHz bus frequency from a 4MHz input. Characterized parameters are derived using a

4MHz loop controlled Pierce oscillator. Production test parameters are tested with a 4MHz square wave

oscillator.

MC9S12XHY-Family Reference Manual, Rev. 1.01

Freescale Semiconductor

727

▷