TCI6630K2L Datasheet, PDF (190/298 Pages) Texas Instruments – Multicore DSP+ARM KeyStone II System-on-Chip

TCI6630K2L
SPRS893E – MAY 2013 – REVISED JANUARY 2015
www.ti.com
Figure 9-21. Boot Complete Register (BOOTCOMPLETE)
31
10
9
8
7
Reserved
BC9 BC8
R,-0
RW-0 RW-0
Legend: R = Read only; RW = Read/Write; -n = value after reset
Reserved
R,-0
4
3
2
BC3
BC
RW-0 RW-0
1
BC1
RW-0
0
BC0
RW-0
Bit
31-10
9
Field
Reserved
BC9
8
BC8
7-4 Reserved
3
BC3
2
BC2
1
BC1
0
BC0
Table 9-37. Boot Complete Register Field Descriptions
Description
Reserved.
ARM CorePac 1 boot status
• 0 = ARM CorePac 1 boot NOT complete
• 1 = ARM CorePac 1 boot complete
ARM CorePac 0 boot status
• 0 = ARM CorePac 0 boot NOT complete
• 1 = ARM CorePac 0 boot complete
Reserved.
C66x CorePac 3 boot status
• 0 = C66x CorePac 3 boot NOT complete
• 1 = C66x CorePac 3 boot complete
C66x CorePac2 boot status
• 0 = C66x CorePac 2 boot NOT complete
• 1 = C66x CorePac 2 boot complete
C66x CorePac1 boot status
• 0 = C66x CorePac 1 boot NOT complete
• 1 = C66x CorePac 1 boot complete
C66x CorePac0 boot status
• 0 = C66x CorePac 0 boot NOT complete
• 1 = C66x CorePac 0 boot complete
The BCx bit indicates the boot complete status of the corresponding C66x CorePac. All BCx bits are sticky
bits — that is, they can be set only once by the software after device reset and they will be cleared to 0 on
all device resets (warm reset and power-on reset).
Boot ROM code is implemented such that each C66x CorePac sets its corresponding BCx bit immediately
before branching to the predefined location in memory.
9.2.3.11 DSP BOOTADDR NS Registers (DSP_BOOT_ADDR0_NS to DSP_BOOT_ADDR3_NS)
DSP_BOOT_ADDR0_NS through DSP_BOOT_ADDR3_NS registers control the boot address for C66x
CorePac 0 through C66x CorePac 3 in non-secure mode in either secure device or non-secure device
respectively. The DSP_BOOT_ADDRx_NS Register is shown in Figure 9-22 and described in Table 9-38.
Figure 9-22. DSP Non-Secure BOOTADDRx Register (DSP_BOOT_ADDRx_NS)
31
10 9
0
BA_RST_VAL[21:0]
Reserved
R/W-0
R-0
Legend: R = Read only; RW = Read/Write; -n = value after reset
Table 9-38. DSP Non-Secure BOOTADDRx Register Field Descriptions
Bit Field
31-10 BA_RST_VAL[21:0]
9-0 Reserved
Description
• C66x CorePacx Boot Address Value [21:0]. The value can be read/written by any master or the
emulator.
190 Device Boot and Configuration
Submit Documentation Feedback
Product Folder Links: TCI6630K2L
Copyright © 2013–2015, Texas Instruments Incorporated